Pioneer PL-L1000

the final frontier
Post Reply
terry-a
senior member
senior member
Posts: 968
Joined: 05 Jan 2013 03:11

Pioneer PL-L1000

Post by terry-a » 14 Sep 2019 22:22

I was given a Phase Linear 8000 (aka Pioneer PL-L1000) a few days ago by the original owner. It's very clean and hasn't seen a lot of use but the belt for the cueing mechanism is dead. A new belt arrived today and I hope to install it soon.

Other than potentially recapping, barring some unforeseen failures yet to be discovered, what might I want to do before I attempt to play a record?

http://gorgephotos.com/images/vinylengi ... inear1.jpg

lenjack
long player
long player
Posts: 2200
Joined: 23 Jun 2017 02:11
Location: Liverpool,PA

Re: Pioneer PL-L1000

Post by lenjack » 14 Sep 2019 23:03

Look for manual in Library.

terry-a
senior member
senior member
Posts: 968
Joined: 05 Jan 2013 03:11

Re: Pioneer PL-L1000

Post by terry-a » 14 Sep 2019 23:36

lenjack wrote:
14 Sep 2019 23:03
Look for manual in Library.
I have the original owner's manual, and I downloaded the 72 page service manual a few days ago.

I would typically change a belt and lube the platter bearing, and perhaps lube a motor, but this is a direct drive plus the platter bearing is some sort of inverted dry bearing or somethingorother. I can clean and test the features for functionality, but I'm wondering what specific issues other's have encountered with this particular machine.

Rothna
junior member
junior member
Posts: 21
Joined: 06 Feb 2011 05:38
Location: McCall, Idaho

Re: Pioneer PL-L1000

Post by Rothna » 30 Sep 2019 21:02

I know this is a bit of a late reply, but the only things I've encountered on mine is making sure the transport rails are clean and checking if the feet suspension rubber boots aren't rotted. New boots can be found by a supplier on etsy.com.

terry-a
senior member
senior member
Posts: 968
Joined: 05 Jan 2013 03:11

Re: Pioneer PL-L1000

Post by terry-a » 01 Oct 2019 17:55

Rothna wrote:
30 Sep 2019 21:02
I know this is a bit of a late reply, but the only things I've encountered on mine is making sure the transport rails are clean and checking if the feet suspension rubber boots aren't rotted. New boots can be found by a supplier on etsy.com.
Thanks.

I've cleaned the rails and replaced the belt for the cueing mechanism, as well as cleaned and lubed the cueing mechanism. I'm going back in to replace the power cord and interconnects with low capacitance wire. While in there I intended to replace the boots with bicycle tube, but if there's a source for boots I may look for them and use them instead.

Post Reply