What pre-amp to use for tube amplifier?

amplifiers, receivers and loudspeakers
Post Reply
KolfMAKER
junior member
junior member
Netherlands
Posts: 13
Joined: 05 Jan 2019 22:13

What pre-amp to use for tube amplifier?

Post by KolfMAKER » 15 Jan 2020 11:37

I have a tube amplifier in a Philips tube radio (model B2X 80U) built in 1958. I have completely restored this unit, and currently it is functioning perfectly.

For my next step I would like to add some modern technology to this receiver. As it has a (switchable) input for a turntable, I would like to use it for attaching a bluetooth receiver (for streaming music to this radio). I have already made a test setup with a bluetooth receiver board (KRC-86B), and it works.

There's only one problem. The audio signal output from the bluetooth receiver board is not strong enough. It means I have to turn the volume quite high to get a reasonable volume. Which also means that when I switch to tuner, the volume blasts my ears off!

Question:
So my question is: what can I best do to get the right audio signal input?

I guess I should put a pre-amp board in between the bluetooth receiver output and the tube radio input.
What board would you suggest? (I am looking at PCB's not pre amp's in casings, as I wil have to built everything inside the radio)


Info:
Attachments
Schermafbeelding 2020-01-15 om 12.32.43.png
(206.09 KiB) Downloaded 21 times
Schermafbeelding 2020-01-15 om 12.33.04.png
(81.20999999999999 KiB) Downloaded 22 times
Schermafbeelding 2020-01-15 om 12.32.51.png
(577.0599999999999 KiB) Downloaded 19 times

Post Reply