regarding bend sub-chassis

a space odyssey
Post Reply
Mikemaxcel_Milano
junior member
junior member
Posts: 11
Joined: 23 Feb 2008 17:45
Location: Milano

regarding bend sub-chassis

Post by Mikemaxcel_Milano » 25 Aug 2016 11:51

After reading post by order014 regarding the bend chassis of Michell,I did recall I once had a first version of the GyroDec,there found the bearing and the armboard are not at the same level after the platter has been level.My remedy was using small pieces of the Bostic BITUMINOUS Pad under the three spacers,and after tightening to level,it stays.
And now I have a chassis bought many years ago and is now mounted with ORBE Platter and bearing,with my own CNC thick Y-SE base.And I am glad that this chassis is perfect as once the platter leveling is done,the armboard is also level with the platter.

Post Reply