Pioneer PL-500 Wiring

the final frontier
Post Reply
afy9
United States of America
Posts: 2
Joined: 13 Aug 2019 22:02

Pioneer PL-500 Wiring

Post by afy9 » 21 Aug 2019 03:10

Hi all. My PL500 sat in my garage in Vegas for 6 years while we were over the pond and needed new lube on the tonearm elevation shaft. While disassembling the arm base from the sub assembly, the green and black wires broke off the PU board. The board is marked for all but the black wire. The service manual seems to shows two wires going to the connection closest to the notch in the board, but I could see where the wire broke off and the connection isn't marked for the black wire, so I'm not sure I should solder the black wire to that connection.

Does anyone have a schematic or pictorial diagram that shows whet this black wire goes on the PU board?

Post Reply