Page 1 of 1

Dual CS 606 Head Shell

Posted: 23 Jun 2019 16:29
by r.armoneit
I have a broken set screw on the head shell that needs replaced. While installing another cartridge the larger screw broke and most of the threads are in the 1/2" adapter, the remaining on the head shell. There is not a lot of info on the CS 606 in English in the library but it looks like the head shell needs replaced or somehow remove the set screw from the head shell and adapter. The smaller set screw to lock in the lift tail is fine! Lesson learned - don't over tighten very fine screws...... I will try to remove the broken screw in the adapter to use again, however the screw in the head shell will present a problem!
Any advice would be appreciated

Re: Dual CS 606 Head Shell

Posted: 23 Jul 2019 19:33
by r.armoneit
Dual CS 606 is spinning again.