I have a TD 166 MkVI with a TP 50 Tonearm and Tp 55 Headshell.
The wand is kinda loose. 2-3° left and right.
When tightening the screw for azimuth of the headshell the wand spins.
Even if I set the correct azimuth this will not stay put because of the wand spinning.
I wonder if there is a way to tighten the wand and avoid spinning.
There are two screws on the sides of the tonearm body but I guess these are not for the wand.
Sorry for my bad writing, I'm from Italy.
Thanks for help.
snap, crackle and pop
1 post • Page 1 of 1