Rega steveson arc protactor

snap, crackle and pop
Post Reply
Nachito culueltu
Spain
Posts: 4
Joined: 11 May 2019 08:52

Rega steveson arc protactor

Post by Nachito culueltu » 14 Dec 2019 10:05

Hello
In the manual to set the cartridge, says That
a second set of lines must be used to check
the alignment. Wich is the 'second set of lines'
Move the cartridge left to right or forward-backward
Thank you.

Alec124c41
vinyl engineer
vinyl engineer
Canada
Posts: 23345
Joined: 28 Oct 2002 03:24
Location: North of Toronto, Canada

Re: Rega steveson arc protactor

Post by Alec124c41 » 14 Dec 2019 12:13

Some arc protractors have the arc and one grid, and some have two grids.
The idea is to move the cartridge back or forward, so that it will follow the arc, when you swing the arm.. Then set it on the crosshairs of the grid, and make sure that the angle is correct, as well.
If there is a second grid, then the cartridge should also line up with it.

Cheers,
Alec

Nachito culueltu
Spain
Posts: 4
Joined: 11 May 2019 08:52

Re: Rega steveson arc protactor

Post by Nachito culueltu » 14 Dec 2019 12:38

Ah, OK thank you, I see well, now

Post Reply