JVC AL-A110 Motor not working - Help debugging?

snap, crackle and pop
Post Reply
mchang6137
United States of America
Posts: 1
Joined: 22 Oct 2018 04:00

JVC AL-A110 Motor not working - Help debugging?

Post by mchang6137 » 22 Oct 2018 04:33

I recently picked up a JVC AL-A110 turntable from my parents. It hasn't been used in probably ~20 years, and when I first took it, the plate would turn reliably if the stylus was moved over the platter.

Fast forward a few weeks (while I was waiting for a new needle to arrive), the plate no longer turns reliably. I took off the metal plate and removed the belt, and *sometimes* I can see the motor turning. I usually have to nudge it a few times (where I can feel it the motor start and stop), but after a few times, it turns somewhat smoothly.

However, when I place the belt back on and replace the platter, the plate doesn't spin, even if I nudge the motor through the hole on the plate a few times. I can see the motor spinning, but it doesn't seem to be spinning with sufficient strength to turn the plate.

Could I get some debugging Help? Any suggestions very much appreciated.

Spinner45
long player
long player
United States of America
Posts: 2153
Joined: 01 Mar 2017 18:21

Re: JVC AL-A110 Motor not working - Help debugging?

Post by Spinner45 » 22 Oct 2018 07:02

A drop of oil maybe works wonders.

vanakaru
member
member
Posts: 175
Joined: 24 Mar 2015 10:05

Re: JVC AL-A110 Motor not working - Help debugging?

Post by vanakaru » 22 Oct 2018 07:38

Keep in mind that WD40 is not a lubricant. And only a small drop fine (sewing machine)oil into the bearing is needed.

Post Reply