My Experience with AT-LH13/OCC Headshell

always listening
Post Reply
hi_torq
member
member
Posts: 57
Joined: 04 Aug 2008 20:11
Location: Essex, UK

My Experience with AT-LH13/OCC Headshell

Post by hi_torq » 10 Aug 2019 21:32

For the benefit of anyone in the market for a new headshell, I though I'd share this.

Now, unless you are specifically looking for a shell with adjustable azimuth (sideways tilt) and overhang, the chances are you won't have heard of these. However, I believe that this product deserves more attention. It's a very finely-engineered and specialist piece of hardware, made in Japan, that has nothing to do with AT's "disco decks". It eliminates at a stroke the issue of misalignment due to manufacturing error that cannot otherwise be corrected. (Interestingly, a HFC review of the Technics EPA-100 highlighted this problem!)

Straight away there is a dilemma: Which to choose - 13, 15 or 18g? Well, I opted for the 13 (on the basis that more mass can be added if necessary) and I'm glad I did. My Jelco SA-370 only just balances out with an AT-110E attached, and in this case the 15 or 18g would have presented a problem. (The stock headshell for this arm weighs in at 8g.)

The next point to note is that, in cases where it is necessary to mount the cartridge in a rearward position (i.e. where the arm pivot has been set too close to the spindle), there may not be enough clearance behind to use the lead wires supplied (due to their sleeved lugs). I would postulate that this shell has been designed primarily for short-bodied moving-coils (and also given the high mass which is better suited to low-compliance MCs).

Finish and precision are excellent. Even the finger-lift has a silicone coating - presumably to damp resonances. And of course, the benefits of azimuth and overhang adjustment that can be performed without dismounting from the arm are manifold. In addition, the headshell is as rigid as possible, quite unlike a regular type where the connector block is 'stamped' on.

Highly recommended then, notwithstanding certain points to consider.
IMAG1767.jpg
(116 KiB) Downloaded 66 times
(A dusty disc - how embarrasing!)

iShootRAW
junior member
junior member
Mexico
Posts: 24
Joined: 17 Oct 2019 00:20
Location: Las Vegas

Re: My Experience with AT-LH13/OCC Headshell

Post by iShootRAW » 27 Oct 2019 06:17

The AT-LH13/OCC Headshell Is probably one of my favorite Audio-Technica Headshells. It works and looks great with my AT-OC9XSL. I would defiantly recommend it to anyone who is looking for a Headshell for their OC9 Series or AT33 Series Cartridge.
Attachments
9FE59BC6-CE63-4187-A2EA-A191BE84A9C7.jpeg
(202.98 KiB) Downloaded 19 times

Post Reply