lini wrote:On the second page in the last illustration on the right side you'll see a point marked "S". That's where the excenter should be.
OK, I find this excenter, but I can't move it
PS. Maybe WD-40 once again?
lini wrote:But you'd probably best first measure the record in question, 'cause if the required radius was less than 116 mm, it would be out of the adjustment range anyway.../ lini
I don't think so, because this same problem is on few SP's
BulldozerPT wrote:Actually I performed this adjustment myself on my CS505-4 and it is dead simple. Nothing to be afraid of.
Thank You for encouragement!