linn axis running slow until warmed up?

[silvertone]

anyone venture a guess why the linn table runs a touch slow until an hours worth of run time, then seems all is fine.....any ideas?

I've swapped out all 4 of the larger caps already,
the belt is new and
it is lubed up and turns nice.

so I'm guessing something electronic either on the board or relating to the motor?

[silvertone]

edit: Actually , I think it's still running slow even after warm up. Seems like 3-4 secs longer for typical 3-4 min song. It's noticeable......anyone know what part of the electronics can be used to speed this up? a resistor somewhere?

[Mark E Smith's Dentist]

There are a couple of variable resistors accessible through the base of the plinth. They're not big and they may have blanking covers over them but they do the job. I can't even remember if they're marked 33 and 45.

If you don't have a strobe to measure you can always count 100 revs in 3m dead. A strobe is a good thing to have though!


JT

[silvertone]

thanks for the info....spent some time on it and got it dialed in. the trim pot is very sensitive (insensitive) and a little bit of turn does alot (too much), but seems good now. thanks again....