springer wrote:Chooooooonnnnn!!! as the kids are wont to say. But, your platter isn't spinning flat.
I noticed that in my video too.
I took the mat off and it appears the top of the platter is spinning flat. Obviously my tone arm/cart are bobbing up/down in my vid though.
The bottom of the platter is not square, but I'm not too surprised by that.
Is it possible my mat is off? LOL. Possibly that particular record is in play as well.
Need to video one of my 180g MoFi's and see ....
I'm not thrilled with how the platter sits on this table. It's a brass looking cone shaped piece of metal on the motor shaft that goes into a like shaped hole in the platter. I would think a squarely machined resting surface would be better. Bet this design was/is cheaper to produce though....
Once I upgrade to an RP6, I'll forget all about this lil guy's 'wobbles'.