Would appreciate any advice that may stop me from pulling out what little hair i have left
Brief outline of issues
Bought QL-Y3F with the following faults
Only up worked on the tonearm
Auto start didn't work, it only started the platter and lifted the arm
Auto stop lifted the arm but you then had to bounce the arm so the rest of the auto stop would proceed.
I have stripped the tonearm completely and rebuilt and now the things just gone nuts!
Up works but down only works whilst in the arm support, as soon as you move it to the disk it wont go down.
Auto start and auto stop now works but the arm travels so fast to the start or stop position that it bounces around laterally. Stripping the arm and rebuilding has obviously done something but im just not clued up enough with electronics to know what the problem is. Im not much good with a multimeter and found the service manual pretty poor.