Replaced LEDs on 1210 - FAIL :-(

[robgmixes]

I just swapped over the 33/45 leds for blue ones, and they do not work as anticipated..The 33 comes on and stays on even if I press the 45 button. The 45 LED however never comes on. I have inspected for dodgy soldering, especially as its a bit tight in that corner, but to no avail. Any ideas?

[cafe latte]

Put the old ones back and see what happens. Not all leds are the same voltage, maybe this is affecting something? Also leds require a specific orientation, did you solder them in the correct way round?
CL

[djsmootht]

Check to see if any solder from the 33 and 45 might have contacted any other points on the PCB board. You can always desolder and start over. I recommend using the solder sucker too, don't use solder wick because they don't work as well and can pull off contact points on your PCB