Any Idea What's happening here?

[Blue Angel]

Hi Gents

I have a Leak Troughline 11 valve tuner which is in A1 condition and which I can listen to through any type of pre or amplifier - s/s or valve, without any problems until now.

I recently got this little Dynaco valve integrated SCA-35 amp and tried to lay the Leak by hooking it up to the Dyna's "RADIO" input and it sounds just all mud. Besides sounding bad and fuzzy, I also needed to crank the volume up way past 12 to get any reasonable volume.

When I started using the SCA-35, I virtually 'ran it in' continuously for days by using a s/s tuner and using it this way, the Dyna sounds superb.

I also tried the Leak into the Dyna's "SPARE" input but this doesn't work either.

Do you have any idea why the Dynaco doesn't like the Leak?

Thanks

blue angel
_________________
"If you don't like my principles, I have others" - Groucho Marx

[bauzace50]

Hello Blue Angel!

Maybe the impedances are off on both tuner and amplifier, and they are a mismatch? Age may have affected both impedances, or maybe they are specified originally wrong for each other? A glance at their spec sheets may begin to clarify things.
Best wishes,
b50
_________________
Let's take it again from: "Oh yeah?! What do you aim to do about it?!"

[Blue Angel]

Thanks for your kind attentions, b50. I think you're on the right track here. As much as I'd like to put the Dynaco into service, renewing essentials like capacitors and drifted out of spec resistors is unavoidable. I was just surprised the SCA-35 works so well with the little s/s portable tuner but not the Leak Troughline 11.

I'll just have to hold my horses until everything is up to snuff again.

Regards

ba
_________________
"If you don't like my principles, I have others" - Groucho Marx